Mon-Fri: 7AM-8PM, Sat: 8AM-6PM, Sun: 9AM-5PM Licensed & Insured [email protected] Serving Weldon Spring, MO

Holmes Garage Door Torsion Spring Replacement in Weldon Spring, MO

Torsion springs replaced and wound correctly, with high-cycle upgrades available. Typical cost $200-$450.

Need Holmes Garage Door torsion spring replacement in Weldon Spring, MO? We diagnose the problem, give you a price before any work starts, and finish most jobs in a single visit. Torsion springs replaced and wound correctly, with high-cycle upgrades available. Whether your Holmes Garage Door garage door is a few years old or a few decades, we can diagnose it and tell you honestly whether it is worth repairing.

Safety first: springs and cables hold hundreds of pounds of tension. Don't try to adjust or remove them yourself, and don't run the opener on a door that's crooked or has a broken spring.

When to call for Holmes Garage Door torsion spring replacement

  • A gap in the spring mounted on the bar above the door
  • The door slams shut or won't stay open
  • Only one side of the door lifts and the door goes crooked
  • The door is suddenly too heavy to lift by hand

Common causes

  • Normal fatigue at the end of the spring's rated cycles
  • Rust or lack of lubrication
  • An undersized spring working too hard
  • A door that's been made heavier with insulation or new panels

What you can check yourself

  • Count the springs above the door. Two-spring doors should have both replaced together.
  • Look for rust or dry, squeaky coils, which are signs the spring is wearing out.
  • Note how often the door is used each day so the right cycle rating can be chosen.

Still stuck? Our free symptom checker and troubleshooting wizard walk you through it step by step.

How we handle Holmes Garage Door torsion spring replacement

  1. Clamp the door and unwind the old springs with proper winding bars
  2. Measure wire size, inside diameter and length, and weigh the door
  3. Install correctly rated springs, upgrading to high-cycle if you use the door a lot
  4. Wind to the right number of turns and set the door's balance
  5. Lubricate, adjust the cables and test the full travel

Wayne Dalton TorqueMaster doors keep the springs inside the torsion tube and need TorqueMaster-specific parts, which we can source.

Typical Holmes Garage Door torsion spring replacement prices

$200-$450Typical range, parts & labor
1-2 hoursTypical time on site

What moves the price:

  • Door size and weight (single or double, steel or wood)
  • Which parts need replacing and whether they are in stock
  • Spring type and cycle rating
  • Emergency or after-hours timing

These are typical U.S. ranges, not a quote. You get an exact price for your door before any work starts. For a quick estimate, try the repair cost calculator.

Other Holmes Garage Door services

Serving Weldon Spring, MO and nearby towns

The swing from hot, humid summers to freezing winters in Missouri is hard on spring steel. Rust shortens spring life, and the first cold snap is when a worn spring tends to break.

Our Holmes Garage Door torsion spring replacement service covers Weldon Spring (ZIP codes 63304, 63338 and 63368) and nearby towns including Cottleville (3 mi), Dardenne Prairie (4.4 mi), O'Fallon (6.7 mi) and Saint Peters (6.9 mi). Call (833) 435-8883 to book a visit in Weldon Spring.

Holmes Garage Door Torsion Spring Replacement: frequently asked questions

How much does Holmes Garage Door torsion spring replacement cost in Weldon Spring, MO?

Holmes Garage Door Torsion Spring Replacement typically costs $200-$450 including parts and labor, and usually takes 1-2 hours. The exact price depends on your door and the parts it needs, and you get it before any work starts. Call (833) 435-8883 for a quote.

Can you do Holmes Garage Door torsion spring replacement the same day?

Often, yes. When a technician is available we can usually come the same day, and common parts are carried on the truck. Doors that won't close or have a broken spring are treated as priority calls, and emergency service is available.

Is Holmes Garage Door torsion spring replacement covered by a warranty?

Our work comes with a 90-day labor warranty on repairs. New parts and doors also carry the manufacturer's warranty, and Holmes Garage Door warranty terms vary by product and age. Ask for the warranty details in writing with your quote.

Are your technicians licensed and insured?

Our technicians are insured, and where Missouri or Weldon Spring requires a contractor license for garage door work, the job is done under that license. You're welcome to ask for proof when you book.

Should I repair or replace my garage door?

A good rule of thumb: if the repair costs more than about 50% of a replacement, or the garage door is near the end of its life, replace it. A garage door typically lasts 15 to 30 years. If several panels are damaged, the door is rusted through or rotted, or parts are discontinued, replacing it is often better value. Springs are the exception: a broken spring is always replaced, never repaired. Our free repair vs. replace calculator can help you compare.

More services

Popular Garage Door Services in Weldon Spring, MO

Steel Garage Door Repair

Dents, rust and bent sections on steel doors repaired or replaced.

Typical $150-$600

Ryobi Opener Circuit Board Replacement

Ryobi's garage door opener can use the brand's 18V ONE+ batteries as backup power and has accessory ports for add-ons.

Typical $175-$400

Stanley Opener Gear & Sprocket Replacement

Stanley garage door openers are no longer made. Compatible remotes and some parts are still available for older units.

Typical $125-$275

Northwest Door Garage Door Roller Replacement

Worn steel or plastic rollers swapped for quiet, sealed nylon rollers.

Typical $150-$350

Battery Backup Opener Installation

Openers with battery backup so the door works during power outages.

Typical $450-$950

Haas Door Off-Track Garage Door Repair

Haas Door, based in Wauseon, Ohio, makes residential and commercial sectional and rolling doors.

Typical $175-$450

CHI Overhead Doors Garage Door Roller Replacement

CHI Overhead Doors builds residential and commercial sectional doors in Arthur, Illinois, and sells them through independent dealers.

Typical $150-$350

Janus International Roll-Up Door Repair

Janus International is a major maker of roll-up doors for self-storage facilities.

Typical $150-$600

Hörmann Opener Circuit Board Replacement

Failed logic boards and receivers replaced, often after a power surge.

Typical $175-$400

Allstar Garage Door Opener Repair

Allstar openers are no longer made. Replacement remotes and many parts are still available, and we'll tell you when replacing the opener makes more sense.

Typical $125-$350

Hörmann Garage Door Sensor Repair

Photo-eye sensors realigned, rewired or replaced so the door closes reliably.

Typical $100-$250

Sommer Opener Circuit Board Replacement

Sommer openers, made in Germany, put the motor on a carriage that travels along the rail instead of hanging from the ceiling, so servicing them is a little different from a conventional opener.

Typical $175-$400

Garage door stuck, noisy or broken?

Talk to a garage door technician in Weldon Spring, MO now. Tell us what the door is doing and we'll give you a price and an arrival window.

Call NowFree Quote